Table of Contents
Advertisement
5A-256 Automatic Transmission:
Manual Shift Shaft Seal and Bearing
Removal
Reference: "Output Gear Assembly Removal".
Special tool
J 45161 Manual Shift Shaft Bearing Replacer
1. Remove the manual shift shaft seal assembly (713)
from the transmission case assembly using a small
pry bar.
2. Using J 45161 and a hammer, drive the manual shift
shaft bearing (714) through the transmission case
assembly bore to remove the bearing.
Reference: "Manual Shift Shaft Seal and Bearing
Installation".
Manual Shift Shaft Seal and Bearing
Installation
Reference: "Manual Shift Shaft Seal and Bearing
Removal".
Special tool
J 45161 Manual Shift Shaft Bearing Replacer
1. Using J 45161 and a hammer, install the manual shift
shaft bearing (714) into the transmission case
assembly until J 45161 is flush with the case bore.
2. Install the manual shift shaft seal (713) by pressing
the seal into the case bore by hand.
Reference: "Output Gear Assembly Installation".
Advertisement
Table of Contents
Troubleshooting
