Table of Contents
Advertisement
2. Install the transaxle fluid level indicator bolt onto the
transaxle.
Tightening torque
Tighten the bolt to 10 N⋅m (89 lb in).
Input Speed Sensor Replacement
Removal Procedure
1. Remove the battery tray. Refer to "Battery Tray
Replacement: " in Engine Electrical.
2. Disconnect the electrical connector (4)from the input
speed sensor.
3. Remove the input speed sensor bolt.
4. Remove the input speed sensor.
5. Remove the input speed sensor O-ring. Discard the
O-ring.
Automatic Transmission:
Installation Procedure
1. Apply GM T-IV automatic transaxle fluid GM P/N
88900925 to the new input speed sensor O-ring.
2. Install the new input speed sensor O-ring onto the
input speed sensor.
3. Install the input speed sensor to the transaxle.
CAUTION
!
Refer to "Fastener Notice: " in Cautions and
Notices.
4. Install the input speed sensor bolt.
Tightening torque
Tighten the bolt to 6 N⋅m (53 lb in).
5. Connect the electrical connector (4) to the input
speed sensor.
6. Install the battery tray. Refer to "Battery Tray
Replacement: " in Engine Electrical.
5A-217
Advertisement
Table of Contents
Troubleshooting
