Suzuki XL7 2007 Service Manual page 1562

5A-152 Automatic Transmission:
Step
1. Turn OFF the ignition.
2. Disconnect the automatic transmission shift lock control
solenoid.
3
3. Connect a test lamp between the shift lock control solenoid
ground circuit at the connector of the shift lock control
solenoid and battery positive voltage.
Does the test lamp illuminate?
1. Turn OFF the ignition.
2. Connect a test lamp between the shift lock solenoid control
circuit and the shift lock solenoid ground circuit at the
4 connector of the shift lock control solenoid.
3. With a scan tool, command the Shift Lock Solenoid output
control ON and OFF several times.
Does the test lamp turn ON and OFF with each command?
5 Does the test lamp remain illuminated?
Test the control circuit of the automatic transmission shift lock
control solenoid for a short to battery voltage. Refer to "Circuit
6
Testing: " and "Wiring Repairs: ".
Did you find and correct the condition?
Test the control circuit of the automatic transmission shift lock
control solenoid for an open or short to ground. Refer to "Circuit
7
Testing: " and "Wiring Repairs: ".
Did you find and correct the condition?
Inspect for poor connections at the harness connector of the
automatic transmission shift lock control solenoid. Refer to
8 "Testing for Intermittent Conditions and Poor Connections: " and
"Connector Repairs: ".
Did you find and correct the condition?
Inspect for poor connections at the harness connector of the body
control module (BCM). Refer to "Testing for Intermittent
9
Conditions and Poor Connections: " and "Connector Repairs: ".
Did you find and correct the condition?
Repair the open in the automatic transmission shift lock control
10 ground circuit. Refer to "Circuit Testing: " and "Wiring Repairs: ".
Did you complete the repair?
Replace the automatic transmission shift lock control solenoid.
11 Refer "Shift Lock Solenoid/Switch Assembly Replacement".
Did you complete the replacement?
Replace the BCM. Refer to "Control Module References: " for
12 replacement, setup, and programming.
Did you complete the replacement?
1. Use the scan tool in order to clear the DTCs.
2. Operate the vehicle within the Conditions for Running the
13
DTC, as specified in the supporting text.
Does the DTC reset?
Action Yes
Go to Step 4 Go to Step 10
Go to Step 8 Go to Step 5
Go to Step 6 Go to Step 7
Go to Step 13 Go to Step 9
Go to Step 13 Go to Step 9
Go to Step 13 Go to Step 11
Go to Step 13 Go to Step 12
Go to Step 13
Go to Step 13
Go to Step 13
Go to Step 2 System OK
No
—
—
—