Table of Contents
Advertisement
FEEDER (ADF service mode)
DISPLAY (State display mode)
FEEDER (ADF service mode) > DISPLAY (State display mode)
FEEDSIZE
1
Detail
Use Case
Adj/Set/Operate Method
ADJUST (Adjustment mode)
FEEDER (ADF service mode) > ADJUST (Adjustment mode)
DOCST
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
LA-SPEED
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Dspl orgnl size detected by DADF/Cpybrd
To display the original size detected by the DADF/Copyboard.
When checking the paper size recognized by the device after scanning
N/A (Display only)
Adj of DADF img lead edge margin: front
To adjust the leading edge margin on the front side at DADF reading.
Execute this item when the output image after DADF installation is displaced.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
service label.
As the value is incremented by 1, the margin is reduced by 0.1 mm. (The image moves upward.)
- When installing DADF
- When clearing the Reader-related RAM data
- When replacing the SATA Flash PCB
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-30 to 30
mm
0
0.1
Fine adj img ratio: DADF,vert scan,front
To make a fine adjustment of the front side image magnification ratio in vertical scanning direction
at DADF reading.
As the value is incremented by 1, the image is reduced by 0.01% in vertical scanning direction.
(The feeding speed increases, and the image is reduced.)
- When installing DADF
- When replacing the SATA Flash PCB
- When replacing the clearing the Reader-related RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-200 to 200
%
0
0.01
548
8. Service Mode
Advertisement
Table of Contents
