Table of Contents
Advertisement
■ FEED-ADJ
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > FEED-ADJ
REGIST
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
ADJ-C1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
ADJ-C2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
1
Adj of registration start timing: Plain
To adjust the timing to turn ON the Registration Roller in the case of plain paper.
As the value is incremented by 1, the margin on the leading edge of paper is increased by 0.1 mm.
+: Leading edge margin becomes larger.
-: Leading edge margin becomes smaller.
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
When changing the edge margin
When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch positive/negative by +/- key)
and press OK key.
Be sure to enter the adjustment value on the service label after adjustment.
-50 to 50
9
1
Cassette1 write start pstn in horz scan
To adjust the image write start position in the horizontal scanning direction when feeding paper
from the Cassette 1.
As the value is changed by 1, the left margin is changed by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When clearing RAM data, enter the value of service label.
When clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If write start position cannot be adjusted in service mode, execute mechanical adjustment.
-25 to 50
mm
0
1
Cassette2 write start pstn in horz scan
To adjust the image write start position in the horizontal scanning direction when feeding paper
from the Cassette 2.
As the value is changed by 1, the left margin is changed by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
When clearing RAM data, enter the value of service label.
When clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
If write start position cannot be adjusted in service mode, execute mechanical adjustment.
-25 to 50
mm
0
421
8. Service Mode
Advertisement
Table of Contents
