Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > USER
PTJAM-RC
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PDL-NCSW
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PS-MODE
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
CNCT-RLZ
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
Auto reprint setting at PDL print jam
To set to automatically restart printing after jam recovery that occurs with PDL print.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Not automatically reprinted, 1: Automatically reprinted
1
Card mngm setting for PDL print job
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set to make PDL print job to be subject to card management by the Card Reader.
With the setting to enable this mode, PDL print is available only when the card ID of the card
inserted to the Card Reader matches the department ID.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: PDL print is available with no card inserted.
1: PDL print is available only when the card ID matches the department ID in the case that the
card is inserted.
0
Setting of PS print line drawing
To set the image processing at PS print.
Set 8 when line width differs depending on the drawing position although the same line width is
set.
Use case When right and left ruled lines are different in width
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 65535
0 to 7: Spare
8: Strokeadjustment is enabled.
9 to 65535: Spare
0
Setting of connection serialize function
Connection serialize is a function to assure job grouping function of imageWARE Output Manager
Select Edition V1.0.
The setting to enable this mode can avoid job rearrangement because the machine does not
receive job data from other connection until it completes job data reception from the current
connection.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: OFF, 1: ON
0
Connection: Connection to be established through network between multiple hosts (PC, etc).
Job grouping function: A function of imageWARE Output Manager Select Edition V1.0. This is to
prevent job interruption from other PC by group job (sending multiple jobs in 1 session at job
transmission).
492
8. Service Mode
Advertisement
Table of Contents
