Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
DCONRTRY
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Supplement/Memo
FL-START
2
FIX-DLV
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
3RDP-MSG
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
TRR-DLV
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
C1F-DLV
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set of retry at DCON comctn error occur
To set whether to perform retry processing when communication error occurs between the Main
Controller and the DC Controller.
Set 1 to 3 when E733 occurs. Communication error may be avoided by retry. (It is effective
especially when E733-0001/0002/0005 occurs.)
If communication error occurs during finishing job while 3 is set, duplicated pages may be output
due to retry. In such case, set 0 to 2. Since retry is not performed during finishing job, duplication
of pages does not occur, but E733 occurs.
When E733 occurs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When 3 is set, duplication of pages may occur during finishing job.
0 to 3
0: OFF
1: OFF during job, ON in other states
2: OFF during finishing job, ON in other states
3: ON
1
Finishing job: Job that 2-sided print, binding and/or collate set in "Finishing" of the printer driver.
[For customization]
Set arr alm thrshld of Fixing Ass'y
To set the timing to notify the Fixing Assembly LF setting value arrival alarm.
When changing the timing to notify the end of life according to the usage status
Enter the setting value, and then press OK key.
50 to 1000
100
ON/OFF pop-up screen dspl after upgrade
To set whether to display the screen to prompt the user to "Third-Party Software" at the first startup
after upgrading due to change in the platform version.
There will be no occasion to use this item intentionally.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Even if 0 is set, the screen is displayed if CDS-LVUP is set to 0.
0 to 1
0: Hide, 1: Display
0
COPIER> OPTION> FNC-SW> CDS-LVUP
Set Trn Rol LF set VL arr alm notice tmg
To set the timing to notify the transfer roller LF setting value arrival alarm.
When changing the timing to notify the end of life according to the usage status
Enter the setting value, and then press OK key.
50 to 1000
100
Set arr alm thrshld of CST1 Feed Roller
To set the timing to notify the Cassette 1 Transfer Roller LF setting value arrival alarm.
When changing the timing to notify the end of life according to the usage status
Enter the setting value, and then press OK key.
50 to 1000
100
457
8. Service Mode
Advertisement
Table of Contents
