Table of Contents
Advertisement
E302-0101-04
Detection Description
Remedy
E302-0102-04
Detection Description
Remedy
E302-0103-04
Detection Description
Remedy
E315-0007-00
Detection Description
Remedy
E315-000D-00
Detection Description
Remedy
E315-000F-00
Detection Description
Remedy
E315-0027-00
Detection Description
Remedy
Error in paper back white shading
An error in the shading value was detected at white shading.
[Related parts] R1.00
- Harness between the Scanner Unit (back) and the Main Controller PCB
- Scanner Unit (back)
- ADF UNIT
- Main Controller PCB
[Remedy] Check/replace the related parts. After performing the remedy, check that the copy image
is output normally.
Error in paper back black shading
An error in the shading value was detected at black shading.
[Related parts] R1.00
- Harness between the Scanner Unit (back) and the Main Controller PCB
- Scanner Unit (back)
- ADF UNIT
- Main Controller PCB
[Remedy] Check/replace the related parts. After performing the remedy, check that the copy image
is output normally.
Error in paper back shading
Image sampling for shading was not completed.
[Related parts] R1.00
- Harness between the Scanner Unit (back) and the Main Controller PCB
- Scanner Unit (back)
- ADF UNIT
- Main Controller PCB
[Remedy] Check/replace the related parts. After performing the remedy, check that the copy image
is output normally.
Image process device timeout error
Image compression process was not completed within the specified period of time (120 sec) at
scanning.
[Related parts]
- Harness between the CIS Unit and Main Controller PCB
- Main Controller PCB
[Remedy] Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the related harness/cable, connector and parts.
Image process device timeout error
Processing of a JBIG-compressed data was not completed within the specified period of time (120
sec) at printing or SEND.
Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the Main Controller PCB.
Image process device timeout error
Duplication of image data in the memory was not completed within the specified period of time
(120 sec).
Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the Main Controller PCB.
Image process device timeout error
Image processing (change in magnification ratio, rotating, and shifting) was not completed normally
within the specified period of time (120 sec).
Perform the following in the order while checking whether the error is cleared.
1. Reinstall the latest system software using SST or a USB flash drive.
2. Check/replace the Main Controller PCB.
279
7. Error/Jam/Alarm
Advertisement
Table of Contents
