Table of Contents
Advertisement
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > CLEAR
MN-CON
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
CARD
1
Detail
Use Case
Adj/Set/Operate Method
Caution
ALARM
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Related Service Mode
CA-KEY
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Supplement/Memo
Deletion of setting values
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To delete the setting values of address lists, forwarding settings, Settings/Registration and service
mode.
For details, refer to "Backup Data List" in the Service Manual.
When initializing the setting values
1) Select the item, and then press OK key.
The machine is automatically rebooted.
2) Turn OFF/ON the main power switch.
- Output the service mode setting values by P-PRINT before execution. After execution, enter
necessary setting value.
- RAM data is cleared after the main power switch is turned OFF/ON.
COPIER> FUNCTION> MISC-P> P-PRINT
Clear of card ID-related data
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To clear the data related to the card ID (department).
When clearing the data related to the card ID
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
The value is cleared after the main power switch is turned OFF/ON.
Clear of alarm log
To clear alarm log.
When clearing alarm log
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
The alarm log is cleared after the main power switch is turned OFF/ON.
COPIER> DISPLAY> ALARM-2
Deletion of CA certificate and key pair
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To simultaneously delete the CA certificate and key pair which are additionally registered by the
user.
When a service person replaces/discards the device
1) Select the item, and then press OK key.
2) Check that OK is displayed.
3) Turn OFF/ON the main power switch.
- Unless this item is executed at the time of replacement/discard of the device, the CA certificate
and key pair which are additionally registered by the user remain in the HDD, which is a problem
in terms of security.
- Do not execute this item carelessly because the CA certificate and key pair which are additionally
registered are deleted when it is executed. If they are deleted mistakenly, they need to be again
registered by the user. If no CA certificate and key pair are additionally registered, the machine
condition becomes the same as the one at the time of factory shipment.
- When NG is displayed in 2), there is a possibility that deletion was not executed. In this case,
surely execute the deletion by initializing the HDD, etc.
At normal termination: OK!, At abnormal termination: NG!
- The CA certificate is used in the MEAP application with E-RDS and SSL client connection, and
the key pair is used in the SSL function of IPP, RUI and MEAP.
- When the main power switch is turned OFF/ON, the CA certificate and key pair which were
registered at the time of factory shipment are decompressed from the archive , and become
available in the E-RDS/SSL function.
437
8. Service Mode
Advertisement
Table of Contents
