Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFTAR3-R
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
DFTAR3-G
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
DFTAR3-B
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Enter shading target VL (R): front, 3rd
To enter the shading target value of Red on the front side at the third reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1103
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
Enter shading target VL (G): front, 3rd
To enter the shading target value of Green on the front side at the third reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1111
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
Enter shading target VL (B): front, 3rd
To enter the shading target value of Blue on the front side at the third reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value and press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1164
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
405
8. Service Mode
Advertisement
Table of Contents
