Canon imageRUNNER ADVANCE 715 series Service Manual page 458

COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
PDF-RDCT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SJB-UNW 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
CARD-RNG 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SJOB-CL 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Supplement/Memo
MIBCOUNT 2
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
PDF reduction set at forwarding
To set whether to reduce the image for transmission when converting the image received by I-Fax
into PDF for e-mail/file transmission.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Following the current setting, 1: Image reduction
0
Reserve upper limit of secured print job
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the upper limit for the number of reserved jobs in secured print job.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: 50 jobs, 1: 90 jobs, 2: No limit
1
Card number setting (department number)
To set the number of cards (departments) that can be used with the Card Reader.
When setting the number of cards (departments)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 1000
1000
Set of scan job canceling by logout
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to cancel the scan job in operation by logout of the user.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
The job with scanning completed cannot be canceled.
0 to 2
0: Cancel only scan job in waiting state, 1: Cancel all scan jobs, 2: Not canceled
0
Scan job: A job after the scanning operation is completed.
Scope range set of Charge Counter MIB
To set the range of counter information that can be obtained as MIB (Management Information
Base).
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: All charge counters are obtained, 1: Only displayed counter* is obtained, 2: All charge counters
are not obtained
* : Counter specified by the following: COPIER> OPTION> USER> COUNTER 1 to 6
0
COPIER> OPTION> USER> COUNTER1 - COUNTER6
448
8. Service Mode