Error Code; Error Code Details - Canon imageRUNNER ADVANCE 715 series Service Manual

Error Code

Error Code Details

E000-0001-05
Detection Description
Remedy
E001-0001-05
Detection Description
Remedy
E001-0002-05
Detection Description
Remedy
E001-0004-05
Detection Description
Remedy
E003-0001-05
Detection Description
Remedy
E004-0001-05
Detection Description
Remedy
Fixing Assembly: Temperature rise failure
The Fixing Assembly does not reach the specified temperature within the specified time after cold
starting.
[Related parts]
- Fixing Assembly
- Harness between the DC Controller PCB and the Drawer Connector
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] This symptom may occur also when the device is used in an environment where room
temperature is too low.
Fixing Assembly: Abnormally high temperature 1
The Main Thermistor temperature raise to more than the specified level.
[Related parts]
- Fixing Assembly
- Harness between the DC Controller PCB and the Drawer Connector
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Fixing Assembly: Abnormally high temperature 2
The Sub Thermistor 1 temperature raise to more than the specified level.
[Related parts]
- Fixing Assembly
- Harness between the DC Controller PCB and the Drawer Connector
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Fixing Assembly: Abnormally high temperature 3
The Sub Thermistor 2 temperature raise to more than the specified level.
[Related parts]
- Fixing Assembly
- Harness between the DC Controller PCB and the Drawer Connector
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Fixing Assembly: Abnormally low temperature
The Main Thermistor temperature remained lower than the specified level.
[Related parts]
- Fixing Assembly
- Harness between the DC Controller PCB and the Drawer Connector
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Drive Circuit Unit error
Drive Circuit Unit error
[Related parts]
- Fixing Assembly
- Harness between the DC Controller PCB and the Drawer Connector
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
271
7. Error/Jam/Alarm