Table of Contents
Advertisement
■ CLEANING
COPIER (Service mode for printer) > OPTION (Specification setting mode) > CLEANING
PR-CLN
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
■ FEED-SW
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FEED-SW
EVLP-FS
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Set Fix Pressure Roll clean dspl condtn
To set the conditions to display the message prompting to clean the Fixing Pressure Roller.
When the number of continuous 1-sided prints exceeds the setting value while PRCLNSW is set
to 1, the message is displayed.
By executing a 2-sided job or cleaning, the Counter for this mode is reset.
When a soiled image occurs because toner adheres to the Fixing Pressure Roller
Enter the setting value, and then press OK key.
If the value is too large, image soiling may occur.
1 to 50
1: 1000 sheets
2: 2000 sheets
3: 3000 sheets
...
50: 50000 sheets
2
COPIER> OPTION> DSPLY-SW> PRCLNSW
Set of fix speed when feeding envlp
To set the stop and the fixing speed of arch control when feeding envelope.
The fixing speed can be set by 0.5% increments.
Decrease the value when fine line displacement occurs on trailing edge of envelope, and increase
the value when wrinkles occur.
When fine line displacement or wrinkles occur on trailing edge while feeding envelope
Enter the setting value, and then press OK key.
Be sure to set the value a little at a time. Otherwise, fixing offset/fixing failure occurs when setting
an extreme value.
-4 to 3
-4: No arch control/fixing speed-2.0%
-3: No arch control/fixing speed-1.5%
-2: No arch control/fixing speed-1.0%
-1: No arch control/fixing speed-0.5%
0: OFF (Default)
1: No arch control/fixing speed+0.0%
2: No arch control/fixing speed+0.5%
3: No arch control/fixing speed+1.0%
0
478
8. Service Mode
Advertisement
Table of Contents
