Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
LED-CLR2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED2CLR2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST3CL0
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST3CL1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST3CL2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
1
Adj sec lgt src lgt time: frt,clr,300dpi
To adjust the lighting time of the LED which is the secondary light source of the Scanner Unit
(Front) in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 2928
1648
COPIER> FUNCTION> CCD> CL-AGC
1
Adj sec lgt src lgt time: frt,clr,600dpi
To adjust the lighting time of the LED which is the secondary light source of the Scanner Unit
(Front) in color mode with 600 dpi.
The value is updated by executing CL-AGC.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 2928
2816
COPIER> FUNCTION> CCD> CL-AGC
1
Adj CIS-ch0 offset: back,clr mode,300dpi
To adjust the offset value (black level) of the Scanner Unit (Back) on channel 0 in color mode with
300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
1
Adj CIS-ch1 offset: back,clr mode,300dpi
To adjust the offset value (black level) of the Scanner Unit (Back) on channel 1 in color mode with
300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
1
Adj CIS-ch2 offset: back,clr mode,300dpi
To adjust the offset value (black level) of the Scanner Unit (Back) on channel 2 in color mode with
300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
411
8. Service Mode
Advertisement
Table of Contents
