Table of Contents
Advertisement
■ DENS
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > DENS
DENS-ADJ
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Supplement/Memo
■ BLANK
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > BLANK
BLANK-T
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
BLANK-L
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
1
Density correction of copy image
To correct the density of copy image by changing the F-value table.
When replacing the DC Controller PCB/clearing RAM data, enter the value of service label.
Blurring is alleviated when the value is increased, and fogging is alleviated when the value is
decreased.
When fogging or blurring at high density area occurs with a copy image
Enter the setting value, and then press OK key.
Density of printer output image cannot be corrected.
1 to 9
5
F-value table: shows the relationship between original density and image density.
1
Adjustment of leading edge margin
To adjust the margin on the leading edge of paper.
As the value is increased by 1, the margin is increased toward the center of the paper by 1 pixel
(0.0212 mm).
- When reducing the margin upon user's request
- When enlarging the margin for transfer separation/fixing separation
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
0 to 1000
pixel
118
0.0212
1
Adjustment of left edge margin
To adjust the margin on the left edge of paper.
As the value is increased by 1, the margin is increased toward the center of the paper by 1 pixel
(0.0212 mm).
When reducing the margin upon user's request
Enter the setting value, and then press OK key.
0 to 1000
pixel
59
0.0212
419
8. Service Mode
Advertisement
Table of Contents
