Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
GAIN4CL0
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED3CL
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED3CL2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED4CL
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
LED4CL2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
1
Adj CIS gain level: back,clr mode,600dpi
To adjust the detection level (gain level) of the Scanner Unit (Back) in color mode with 600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 255
0
COPIER> FUNCTION> CCD> CL-AGC
1
Adj pry lgt src lgt time:back,clr,300dpi
To adjust the lighting time of the LED which is the primary light source of the Scanner Unit (Back)
in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
1648
COPIER> FUNCTION> CCD> CL-AGC
1
Adj sec lgt src lgt time:back,clr,300dpi
To adjust the lighting time of the LED which is the secondary light source of the Scanner Unit (Back)
in color mode with 300 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
1648
COPIER> FUNCTION> CCD> CL-AGC
1
Adj pry lgt src lgt time:back,clr,600dpi
To adjust the lighting time of the LED which is the primary light source of the Scanner Unit (Back)
in color mode with 600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
2816
COPIER> FUNCTION> CCD> CL-AGC
1
Adj sec lgt src lgt time:back,clr,600dpi
To adjust the lighting time of the LED which is the secondary light source of the Scanner Unit (Back)
in color mode with 600 dpi.
The value is updated by executing CL-AGC.
- When replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
Enter the setting value, and then press OK key.
0 to 2928
2816
COPIER> FUNCTION> CCD> CL-AGC
414
8. Service Mode
Advertisement
Table of Contents
