Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > DSPLY-SW
CE-DSP
2
LOCAL-SZ
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
T-LW-BK
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
SND-NAME
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PCMP-DSP
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
[Reserve]
ON/OFF area-spec stdrd size ppr set scrn
To set whether to display the area-specific standard size paper on the paper settings screen in
[Settings/Registration].
When 1 is set, paper type (FOOLSCAP, OFFICIO, etc.) can be set on the paper settings screen
for each paper source.
Upon user's request
Enter the setting value, and then press OK key.
0 to 1
0: OFF, 1: ON
It differs according to the location.
Preferences> Paper Settings> Paper Settings
Set toner level warning mssg dspl timing
To set the threshold value for the toner level in the Toner Container.
When the toner level becomes below the threshold value while TNR-WARN is 0, a toner level
warning message "Toner is low. Replacement not yet needed." is displayed on the Control Panel.
As the value is incremented by 1, the threshold value is increased by 1%. As the value is larger,
the timing to display the message becomes earlier.
When changing the timing to display the toner level warning message for the user to whom toner
is not delivered automatically
Enter the setting value, and then press OK key.
0 to 40
%
It differs according to the location.
COPIER> OPTION> DSPLY-SW> TNR-WARN
It is not linked with COPIER> OPTION> FNC-SW> T-DLV-BK.
Setting of [Scan and Send] button name
To set the name of [Scan and Send] button displayed in the main menu.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2
0: [Scan and Send], 1: [Scan], 2: [Scan]
0
Set copy cmpl scrn dspl:chg w/devc alone
To set whether to display the screen indicating completion of copying at the time of charging with
a device alone.
When 0 is set, a message "Copying is complete. Do you want to start the job again with the same
settings?" is not displayed in a pop-up screen.
When COIN is 4, this setting is enabled.
Upon user's request
Enter the setting value, and then press OK key.
0 to 1
0: OFF, 1: ON
1
COPIER> OPTION> ACC> COIN
463
8. Service Mode
Advertisement
Table of Contents
