Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-RDR
DF2DSTL1
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Supplement/Memo
■ IMG-MCON
COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-MCON
SHARP
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
VP-ART
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Adj dust dtct level:strem, ppr int, back
To adjust dust detection level that is executed in the Scanner Unit (Paper Back) at paper interval
at the stream reading with DADF (1-path model).
Reduce the value in the case of frequent display of cleaning instruction at the time of dust detection.
As the value is smaller, dust is less likely to be detected.
Increase the value when black lines appear. As the value is larger, the small dust is more likely to
be detected.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
If the value is too large, the cleaning instruction screen may appear too often since even small dust
that will not appear on the image can be detected.
If the value is too small, black lines may appear.
1 to 255
1 to 84: Weakest, 85 to 169: Weak, 170 to 254: Moderate, 255: Strong
200
Black lines may appear on the image if there is dust. With dust detection correction control, the
image is corrected to prevent black lines once dust is detected.
Setting of sharpness level of image
To set the setting level (center value) of sharpness of image.
As the value is increased, the image tends to be sharp, and as the value is decreased, image tends
to be soft.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 5
3
Setting of line art processing
To set outline processing for line art on scalable PDF.
In the outline processing, a binary image outline is extracted in the field which is recognized as
line art, and is converted into vector data.
Specify whether to convert the binary image outline into vector data or to recognize it as one line
(as a thin line). For the thin line, the line width can be specified.
Change this value when you want to obtain an output of a wide-width line as one line rather than
as an outline (when you want to prioritize edit operation as a line rather than image quality).
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 99
1
480
8. Service Mode
Advertisement
Table of Contents
