Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
DFTBK-G
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTBK-B
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTBK-R
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
Enter shading target VL (G): back side
To enter the shading target value of Green on the back side at DADF stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Back), execute DF-WLVL1 and DF-WLVL2 and write the value
which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
0 to 2047
1111
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
Enter shading target VL (B): back side
To enter the shading target value of Blue on the back side at DADF stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Back), execute DF-WLVL1 and DF-WLVL2 and write the value
which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
0 to 2047
1164
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
Enter shading target VL (R): back side
To enter the shading target value of Red on the back side at DADF stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Back), execute DF-WLVL1 and DF-WLVL2 and write the value
which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Back)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When the Copyboard or DADF (reverse model) is installed, the setting of this item is disabled.
0 to 2047
1103
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
404
8. Service Mode
Advertisement
Table of Contents
