Table of Contents
Advertisement
Setting after Installation
1. In the following Service Mode, set the value to "1."
COPIER > FUNCTION > INSTALL > NFC-USE
NOTE:
When [System Manager Information Settings] is set, it is
required to log in as a system manager in accordance with
instructions of the user administrator.
2. Select [Settings/Registration] > [Management
Settings] > [Device Management] > [Use NFC Card
Emulation], and set the item to "ON".
3. Turn OFF and then ON the main power switch.
4. When a message prompting the version update is
displayed, press [Update] and automatically update
the version of this equipment.
CAUTION:
It may take time to display the update screen. (Approx.
1 to 2 min.) During this time, do not operate the
screen.
5. Check the end of the following service mode.
COPIER > DISPLAY > VERSION > PANEL
If the end is an even number (e.g. 01.26): NFC is not
installed.
If the end is an odd number (e.g. 01.27): NFC is
installed.
600
9. Installation
Advertisement
Table of Contents
