Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > LCNS-TR
TR-SCR
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
ST-BRDIM
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-BRDIM
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
ST-VNC
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
TR-VNC
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Trns license key dspl: Encry Secure Pnt
To display transfer license key to use Encrypted Secure Print when disabling and then transferring
the license.
- When replacing HDD
- When replacing the device
1) Select ST-SCR.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-SCR.
This mode is enabled when there is "3DES+USH-H" Board.
24 digits
Install state dspl: PCL Barcode Printing
To display installation state of BarDIMM when disabling and then transferring the license.
When checking whether Barcode Printing for PCL is installed
1) Select ST-BRDIM.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-BRDIM.
When operation finished normally: OK!
According to the setting at shipment
Trns lcns key dspl: PCL Barcode Printing
To display transfer license key to use Barcode Printing for PCL when disabling and then
transferring the license.
- When replacing HDD
- When replacing the device
1) Select ST-BRDIM.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-BRDIM.
24 digits
Install state dspl of Remote Oprtr Soft
To display installation state of Remote Operators Software when disabling and then transferring
the license.
When checking whether Remote Operators Software is installed
1) Select ST-VNC.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-VNC.
When operation finished normally: OK!
According to the setting at shipment
Trns lcns dspl of Remote Operators Soft
To display transfer license key to use Remote Operators Software when disabling and then
transferring the license.
- When replacing HDD
- When replacing the device
1) Select ST-VNC.
2) Enter 0, and then press OK key.
The transfer license key is displayed under TR-VNC.
24 digits
512
8. Service Mode
Advertisement
Table of Contents
