Canon imageRUNNER ADVANCE 715 series Service Manual page 282

E004-0004-05
Detection Description
Remedy
E004-0005-05
Detection Description
Remedy
E012-0001-05
Detection Description
Remedy
E012-0002-05
Detection Description
Remedy
E014-0001-05
Detection Description
Remedy
E014-0002-05
Detection Description
Remedy
Mismatching Fixing Type
- "Fixing Assembly Absence" was detected as a result of the Fixing Assembly Connection
Determination
- The temperature of the Main Thermistor and the Sub Thermistor was lower than the specified
level.
[Related parts]
- Fixing Assembly
- Harness between the DC Controller PCB and the Drawer Connector
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Low Voltage Power Supply Unit
When an error occurred in the communication with the effective value detection IC.
[Related parts]
- Low Voltage Power Supply PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Drum Motor startup error
The startup of Drum Motor does not complete within the specified period of time after start.
[Related parts]
- Drum Motor (M2)
- Harness between the Drum Motor and the DC Controller PCB
- DC Controller PCB
- Main Drive Unit
[Remedy] Check/replace the related harness/cable, connector and parts.
Drum Motor Rotation error
The number of rotations of the Drum Motor decreased to less than the specified value during
operation.
[Related parts]
- Drum Motor (M2)
- Harness between the Drum Motor and the DC Controller PCB
- DC Controller PCB
- Main Drive Unit
[Remedy] Check/replace the related harness/cable, connector and parts.
Fixing Motor startup error
The startup of the Fixing Motor does not complete within the specified period of time after start.
[Related parts]
- Fixing Motor (M1)
- Harness between the Fixing Motor and the DC Controller PCB
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
Fixing Motor rotation error
The number of rotations of the Fixing Motor decreased to less than the specified value during
operation.
[Related parts]
- Fixing Motor (M1)
- Harness between the Fixing Motor and the DC Controller PCB
- DC Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
272
7. Error/Jam/Alarm