Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
JM-ERR-R
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
ASLPMAX
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
SEND-SPD
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set of error display of 0071 jam (RCON)
To set whether to display 0071 jam as the error "E996-0071".
In the case of a jam, a log may not be able to be obtained depending on the timing.
By selecting 1 when the 0071 jam occurs, it is displayed as an error so that a log can be obtained.
When obtaining a log at the occurrence of 0071 jam
Enter the setting value, and then press OK key.
0 to 1
0: Display as a jam, 1: Display as an error
0
COPIER> OPTION> FNC-SW> JM-ERR-D
Set auto sleep shift time maximum value
Set auto sleep shift time maximum value.
Upon user's request
Enter the setting value, and then press OK key.
0 to 1
0: 4 hours, 1: 60 minutes
It differs according to the location.
ON/OFF of SEND operation speed-up
To set whether to speed up the SEND operation.
Usually, speed of SEND/XBOX is increased by performing image conversion during SEND and
Scan.
Reading speed may decrease when scanning large size color original at high resolution or when
competing operation occurs with another job during scanning. Set 1 to keep the speed.
When failure with MEAP application occurs, set 1.
- When reading speed is decreased during SEND and Scan
- When failure with MEAP application occurs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ON, 1: OFF
0
455
8. Service Mode
Advertisement
Table of Contents
