Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > FEED-SW
TFL-RTC
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
SP-SW
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
■ IMG-RDR
COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-RDR
DFDST-L1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
1
Set delvry dest at rcvry after tray full
To select the delivery destination for a job with multiple pages after recovering the Delivery Tray
that reaches the full level.
When 0 is set, a job is output from the delivery destination again from which the last job was
delivered.
When 1 is set, a job is output from the delivery destination which priority is set as high at "Output
Tray Settings" in [Settings/Registration].
When changing the delivery tray
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Output from the tray from which the last job was output, 1: Output from the delivery destination
which priority is high among the delivery trays
0
Function Settings> Common> Paper Output Settings> Output Tray Settings
1
Disable static elimination control
To set the value to 1 to change the static eliminator bias value to 0V.
When white spots are generated on thin/moist paper in high humidity environment due to excessive
static elimination bias
Enter the setting value, and then press OK key.
0 to 1
0: Static elimination bias ON, 1: static elimination bias OFF
0
1
Adj dust detect level: ppr intvl, DADF
To adjust dust detection level with dust detection correction control that is executed at paper
interval in DADF mode.
Reduce the value in the case of frequent display of cleaning instruction at the time of dust detection.
As the value is smaller, the dust is less detected.
Increase the value when black lines appear. As the value is larger, the small dust is more likely
detected.
- When black line occurs due to dust
- Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When increasing the value too much, the cleaning instruction screen may appear too often since
even small dust that will not be appeared on the image can be detected.
When decreasing the value too much, black lines may appear.
1 to 255
200
COPIER> OPTION> IMG-RDR> DFDST-L2
Black lines may appear on the image if there is dust. With dust detection correction control, the
image is corrected to prevent black lines once dust is detected.
479
8. Service Mode
Advertisement
Table of Contents
