Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
100DF-GB
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
DFTAR-R
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
DFTAR-G
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Amount of Change per
Unit
GB clr displc crrct:DADF,front,vert scan
To correct the color displacement between G and B lines in vertical scanning direction due to the
Scanner Unit (Front) that occurs at DADF reading with 600 dpi.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Scanner Unit (Front), enter the value of service label on a new unit.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Scanner Unit (Front)
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-256 to 256
line
0
0.001
Enter shading target VL (R): front, 1st
To enter the shading target value of Red on the front side at the first reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1103
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
Enter shading target VL (G): front, 1st
To enter the shading target value of Green on the front side at the first reading position at DADF
stream reading.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When replacing the Copyboard Glass/Scanner Unit (Front), execute DF-WLVL1 and DF-WLVL2
and write the value which is automatically set in the service label.
- When clearing the Reader-related RAM data/replacing the SATA Flash PCB
- When replacing the Copyboard Glass/Scanner Unit (Front)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 2047
1111
COPIER> FUNCTION> CCD> DF-WLVL1/WLVL2
1
381
8. Service Mode
Advertisement
Table of Contents
