Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > ADJ-XY
STRD-POS
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
ADJ-X-MG
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ADJY-DF2
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Adj frt side read pstn: DADF stream read
To adjust the Scanner Unit (Front) position in feed direction at DADF stream reading.
As the value is changed by 1, the position moves by 0.1 mm.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-40 to 20
mm
0
COPIER> FUNCTION> INSTALL> STRD-POS
0.1
Fine adj img ratio: book mode, vert scan
To make a fine adjustment of image magnification ratio in vertical scanning direction at copyboard
reading.
As the value is changed by 1, the image magnification ratio is changed by 0.01%.
+: Reduce
-: Enlarge
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-200 to 200
%
0
0.01
Adj read start pstn:DADF,back,horz scan
To adjust the back side image reading start position in horizontal scanning direction at DADF
reading.
As the value is incremented by 1, the image position is moved to the rear side by 0.1 mm.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
the service label on the reader.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-15 to 15
mm
0
0.1
378
8. Service Mode
Advertisement
Table of Contents
