Canon imageRUNNER ADVANCE 715 series Service Manual page 511

COPIER (Service mode for printer) > OPTION (Specification setting mode) > USER
JA-WEB 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
EXP-CRYP 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
SMD-EXPT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
SNDSTREN 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Setting of Inbox document upload: SAM
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the Inbox document upload with the Web browser at the time of iW SAM.
When 1 is set uploading to the Inbox document with the Web Browser is enabled.
When the operation restriction is cleared at the time of iW SAM
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Disabled, 1: Enabled
0
Confdntial encrypt ON/OFF:add book exprt
* Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to encrypt the confidential part (password part) in the Address Book when exporting
the address book and device settings via remote UI.
When 0 is set, the confidential part in the address book is exported without encryption.
When there is a need to export password without encryption because of operation and tool
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Be sure not to allow the user to execute export without encryption because of security concern.
0 to 1
0: OFF, 1: ON
1
Setting of export target data: remote UI
To set whether to export "service mode data" from remote UI.
When 1 is set, "service mode data" is displayed as the target data of export on remote UI. When
installing more than 1 machine at the same time, the same service mode data can be registered.
When installing more than 1 machine at the same time
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Hide, 1: Display
0
If selecting "service mode data" as the target data of export on remote UI after setting SMD-EXPT
to 1, service mode data can be exported.
Set of setting delete aftr scan and send
To set whether to delete the transmission settings except for the address after transmission from
the "Scan and Send" screen.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 3
0: Deleted, 1: Retained only the transmission setting, 2: Retained the transmission setting and
address, 3: Retained only address
It differs according to the location.
501
8. Service Mode