Table of Contents
Advertisement
E732-0F21-00
Detection Description
Remedy
E732-0F22-00
Detection Description
Remedy
E732-0F23-04
Detection Description
Remedy
E732-8888-00
Detection Description
Remedy
E733-0000-05
Detection Description
Remedy
E733-0001-05
Detection Description
Remedy
E733-0002-05
Detection Description
Remedy
Communication error
Communication error that can be recovered by reboot
If it is detected again immediately after reboot, E732-0021 is generated.
It is not necessary to perform a remedy because the machine is automatically rebooted after log
collection.
Communication error
Communication error that can be recovered by reboot
If it is detected again immediately after reboot, E732-0022 is generated.
It is not necessary to perform a remedy because the machine is automatically rebooted after log
collection.
Communication error
Communication error that can be recovered by reboot
If it is detected again immediately after reboot, E732-0023 is generated.
It is not necessary to perform a remedy because the machine is automatically rebooted after log
collection.
Communication error
Scanner for a different model was detected at communication with the Reader.
Replace the Reader Unit with the one for this model.
Printer communication error
A communication error between the DC Controller PCB and the Main Controller PCB was detected
at startup.
[Related parts] R1.00
- Harnesses between the DC Controller PCB and the Main Controller PCB
- DC Controller PCB
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Printer communication error
A communication error between the DC Controller PCB and the Main Controller PCB was detected.
[Related parts] R1.00
- Harnesses between the DC Controller PCB and the Main Controller PCB
- DC Controller PCB
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
Printer communication error
Signal error was detected after establishment of communication between the DC Controller PCB
and the Main Controller PCB.
[Related parts] R1.00
- Harnesses between the DC Controller PCB and the Main Controller PCB
- DC Controller PCB
- Main Controller PCB
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] Before replacing the DC Controller PCB, back up the service mode data (approx. 2
min) and restore the backup data after the replacement so the data may be able to be protected.
- Backup: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMBUP
- Restoration: COPIER (LEVEL2)> FUNCTION> SYSTEM> DSRAMRES
316
7. Error/Jam/Alarm
Advertisement
Table of Contents
