Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > NETWORK
ILOGMODE
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
ILOGKEEP
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
IPTBROAD
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Setting of filter log target packet
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the target packet to be recorded in the filter log.
Usually, only the unicast packets to the machine are recorded in the filter log by PFW (personal
firewall).
When 1 is set, address filter is enabled for all protocols so all packets are recorded in the filter log.
However, logs of multicast/broadcast packets sent from a harmless device or an address that are
subject to rejection and have no direct relation to the machine are also recorded, and consequently
the number of logs is increased.
Upon user's request (to collect all filter logs)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When 1 is set, the number of logs is increased because logs of packets which have no direct
relation to the machine are recorded.
0 to 1
0: Unicast packets to the machine only, 1: All packets
0
Set of IP address block log hold time
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the retention time from the log time of IP block.
When access is made again from a same IP address which was blocked before, if it is within the
retention time of the previous log, its log is not recorded.
If access is frequently made from a same IP address, the log record of the UI might be filled with
its logs. If the user considers that a single log for a same IP address is enough, set the longer
retention time.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 48
0: 1 minute (special mode)
1 to 48: 1 hour to 48 hours
1
Set to allow broad/multicast TX
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to permit transmission of broadcast packets and multicast packets.
Transmission of broadcast packets and multicast packets is permitted without specifying an
exception address. It is permitted within the device even if it is rejected in the default setting of the
IPv4/v6 transmission filter.
Set "1: Disabled" when the user does not want to send them.
Upon user's request
Enter the setting value, and then press OK key.
0 to 5
0: Enabled, 1: Disabled, 2 to 5: Not used
0
473
8. Service Mode
Advertisement
Table of Contents
