Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > NETWORK
SSLSTRNG
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
NW-WAIT
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
WLAN-USE
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
WLANPORT
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
RAW-PORT
2
Allow weak encryption algorithm for SSL
To set whether to allow using weak encryption algorithm for SSL.
When 1 is set, weak encryption algorithm cannot be used.
When prohibiting weak encryption algorithm because of security concern
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Normal mode, 1: Secure mode ( Not used TLS_RSA_WITH_RC4_128_SHA, TLS_RSA_WITH_
RC4_128_MD5)
1
Set connect wait at deep sleep recovery
To set whether to send wakeup notice after the time set in Settings/Registration menu has elapsed
when recovering from deep sleep.
When 0 is set, wakeup notice is sent after "Waiting Time for Connection at Startup" has elapsed.
When 1 is set, wakeup notice is sent when the machine becomes ready for communication.
When a failure of the device management tool occurs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Wait, 1: Not wait
0
Preferences> Network> Waiting Time for Connection at Startup
Setting of wireless LAN invalidation
To set whether to disable the wireless LAN.
Bringing in and installation of the wireless LAN equipment may be prohibited depending on user.
In such case, set 0 to prevent the wireless LAN to be used. When 0 is set, [Wireless Connection
Settings] is not displayed in [Settings/Registration].
When bringing in and installation of the wireless LAN equipment is prohibited
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Disabled, 1: Enabled
1
Preferences> Network> Wireless Connection Settings
Set of port filter at wireless LAN side
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to open all ports at the wireless LAN side.
When 0 is set, only the specific port is opened (filter is enabled).
Set 1 when using an application which uses a port other than the specific port. All ports are opened
(filter is disabled).
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Open the specific port, 1: Open all ports
0
[For customization]
476
8. Service Mode
Advertisement
Table of Contents
