Feeder (Adf Service Mode); Display (State Display Mode); Adjust (Adjustment Mode) - Canon imageRUNNER ADVANCE 715iF III Series Service Manual

FEEDER (ADF service mode)

DISPLAY (State display mode)

FEEDER (ADF service mode) > DISPLAY (State display mode)
FEEDSIZE 1
Detail
Use Case
Adj/Set/Operate Method

ADJUST (Adjustment mode)

FEEDER (ADF service mode) > ADJUST (Adjustment mode)
DOCST 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
LA-SPEED 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
Dspl orgnl size detected by DADF
To display the original size detected by the DADF.
When checking the paper size recognized by the device after scanning
N/A (Display only)
Adj of DADF img lead edge margin: front
To adjust the leading edge margin on the front side at DADF reading.
Execute this item when the output image after DADF installation is displaced.
When clearing the Reader-related RAM data/replacing the SATA Flash PCB, enter the value of
service label.
As the value is incremented by 1, the margin is reduced by 0.1 mm. (The image moves upward.)
- When installing DADF
- When clearing the Reader-related RAM data
- When replacing the SATA Flash PCB
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-30 to 30
mm
0
0.1
Fine adj img ratio: DADF,vert scan,front
To make a fine adjustment of the front side image magnification ratio in vertical scanning direction
at DADF reading.
As the value is incremented by 1, the image is reduced by 0.01% in vertical scanning direction.
(The feeding speed increases, and the image is reduced.)
- When installing DADF
- When replacing the SATA Flash PCB
- When replacing the clearing the Reader-related RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-200 to 200
%
0
0.01
604
8. Service Mode