Table of Contents
Advertisement
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > CLEAR
JV-TYPE
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Related Service Mode
Supplement/Memo
CUSTOM2
2
DUTL-CLR
2
CNT-RCON
1
Detail
Use Case
Adj/Set/Operate Method
■ MISC-R
COPIER (Service mode for printer) > FUNCTION (Operation / inspection mode) > MISC-R
SCANLAMP
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
SCANLMP2
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Specification of MEAP cache clear target
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To specify the MEAP cache area to be cleared.
The target area is divided into the 4 parts:
- A jar file of MEAP application bundled as standard
- Data of the application mentioned above
- A jar file of MEAP application installed additionally
- Data of the application mentioned above
When JV-CACHE is executed, the area specified with this item is cleared.
For details, refer to the Service Manual.
When analyzing the cause of a problem due to MEAP application
Enter the setting value, and then press OK key.
0 to 4
0: Entire MEAP cache area
1: A jar file of MEAP application bundled as standard
2: A jar file and data of MEAP application bundled as standard
3: Data of MEAP application which has been installed additionally
4: A jar file and data of MEAP application which has been installed additionally
COPIER> FUNCTION> CLEAR> JV-CACHE
MEAP applications bundled as standard: system application, built-in login application
MEAP applications installed additionally: non-Canon-made login application, general application,
etc.
[For customization]
For R&D
Clear of RCON service counter
To clear the service counter counted by the RCON management software.
When clearing the service counter counted by the RCON
Select the item, and then press OK key.
Lighting check of Scanner Unit (Frt) LED
To light up the Scanning Lamp for 3 seconds under the White Plate and the Copyboard Glass
respectively.
When replacing the LED of the Scanner Unit
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
Lighting check of Scanner Unit (Bck) LED
To light up the LED of the Scanner Unit (Back) for 3 sec.
Check whether there is a missing block or no lighting in LED.
When replacing the LED of the Scanner Unit
Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
439
8. Service Mode
Advertisement
Table of Contents
