Table of Contents
Advertisement
E614-4003-00
Detection Description
Remedy
E614-4010-00
Detection Description
Remedy
E614-4011-00
Detection Description
Remedy
E614-4012-00
Detection Description
Remedy
E614-9000-00
Detection Description
Remedy
E614-9001-00
Detection Description
Remedy
Error in system on the Flash PCB
The OS boot loader was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is installed properly.
2. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
3. Check that the HDD and the cables are properly installed.
4. Enter safe mode using (2+8) startup, and format the HDD using SST or a USB flash drive.
5. If another error occurs, clear the error by performing the remedy for it.
6. Replace the Main Controller PCB.
Error in system on the Flash PCB
The OS in safe mode could not be recognized.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is installed properly.
2. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Error in system on the Flash PCB
The file for booting the OS in safe mode was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is installed properly.
2. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Error in system on the Flash PCB
The kernel in safe mode was not found.
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is installed properly.
2. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Error in system on the Flash PCB
SRAM device access-related error (at startup)
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is installed properly.
2. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
Error in system on the Flash PCB
Error in memory allocation/invalid memory (at startup)
When this error occurs, the system has not been started normally. Therefore, it may not be
recorded in the error log.
Perform the following in the order while checking whether the error is cleared.
1. After turning OFF the main power, remove and then install the Flash PCB again to check that
it is installed properly.
2. After replacing the Flash PCB, reinstall the system software using SST or a USB flash drive.
309
7. Error/Jam/Alarm
Advertisement
Table of Contents
