Canon imageRUNNER ADVANCE 715 series Service Manual page 492

COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-MCON
DOTSCT 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
SP-GRAD 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
BIN-SEL 2
■ IMG-FIX
COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-FIX
RAG-CONT 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Supplement/Memo
■ CUSTOM
COPIER (Service mode for printer) > OPTION (Specification setting mode) > CUSTOM
SCANTYPE 1
Set high dens area white dot reduct mode
To set the mode to reduce white dots occur in the high density area with 600 dpi.
Set 1 when white dots occur at regular intervals in the high density area. If it is not alleviated, set
2.
Set 0 when degree of gradation in the high density area is decreased due to parts life or
environment.
- When white dots occur at regular intervals in the high density area
- When the degree of gradation is decreased because colors in the high density area become
darker
Enter the setting value, and then press OK key.
- It is enabled only for PDL job.
- When 0 is set, white dots may be significant.
- When 2 is set, gradation in the high density area may become not noticeable.
0 to 2
0: OFF, 1: ON (Weak), 2: ON (Strong)
0
ON/OFF of special gradation processing
To set whether to make the density gradation characteristics of halftone the same as that of
conventional machines.
When making the density gradation characteristic the same as that of conventional machines
Enter the setting value, and then press OK key.
0 to 1
0: ON, 1: OFF
1
For R&D
Set fix smeared image ctrl mode level
To set level of the mode (skipping) to control smeared image caused by fixing area.
When a smeared image occurs
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Set RAG-SW to 1 to 3 to enable skipping.
0 to 3
0: No skipping, 1: Small skipping, 2: Medium skipping, 3: Large skipping
1
When this mode is ineffective, use COPIER> ADJUST> DEVELOP> DE-OFS together.
[Not used]
482
8. Service Mode