Table of Contents
Advertisement
10-0098
A. Operation / B. Cause /
C. Remedy
10-0100
A. Operation / B. Cause /
C. Remedy
10-0404
A. Operation / B. Cause /
C. Remedy
13-0FFC
A. Operation / B. Cause /
C. Remedy
13-0FFE
A. Operation / B. Cause /
C. Remedy
14-0002
A. Operation / B. Cause /
C. Remedy
31-0006
A. Operation / B. Cause /
C. Remedy
31-0008
A. Operation / B. Cause /
C. Remedy
31-0009
A. Operation / B. Cause /
C. Remedy
31-0060
A. Operation / B. Cause /
C. Remedy
31-0061
A. Operation / B. Cause /
C. Remedy
Cartridge memory detection alarm
Cause: Memory of cartridge could not be detected.
Measures:
1. Remove and then install the Cartridge.
2. Check for any scar or soiling on the memory area of the Cartridge.
3. Replace the Cartridge.
Cartridge replace notice
The replacement of the Cartridge was detected.
Cartridge empty alarm
When the cartridge empty was detected
For R&D
For R&D
For R&D
HDD failure when equipped with the mirroring function
HDD failure when equipped with the mirroring function
HDD failure prediction alarm
Movement: HDD failure is expected to occur in a short time due to occurrence of physical error in
HDD. It does not occur in the HDD of mirroring configuration.
Cause: Error in the S.M.A.R.T. value of HDD
Measures:
1. Back up the data stored in HDD.
2. Replace the HDD.
3. Restore the data.
S.M.A.R.T. (Self-Monitoring Analysis and Reporting Technology): Self-diagnosis function built in
the HDD. The occurrence rate of reading error, reading and writing speed, the total number of
Motor start-up and stop times, the total length of power-on time, etc. are monitored.
FLASH failure prediction alarm
Cause: Error in the S.M.A.R.T. value of FLASH memory It indicates a physical error of the FLASH
memory, which is expected to soon lead to a failure.
*: S.M.A.R.T. (Self-Monitoring Analysis and Reporting Technology) = It is a self-diagnosis function
built in the FLASH memory, and monitors the occurrence rate of reading errors, reading/writing
speed, total number of times of motor start-up/stop, total length of power-on time, etc.
Continuously using the machine without taking any measures may lead to E614.
Measures: Back up the data stored in the FLASH memory, and restore the data after replacing the
FLASH memory.
Warning in accessing the NVRAM
Communication with EEPROM in the DCON PCB was not available.
Remedy:
Replace the DCON PCB.
Warning in accessing the NVRAM
Communication with EEPROM in the DCON PCB was not available.
Remedy:
Replace the DCON PCB.
328
7. Error/Jam/Alarm
Advertisement
Table of Contents
