Minimum Clearance Requirements - Allen-Bradley Kinetix 5700 User Manual

Chapter 2 Plan the Kinetix 5700 Drive System Installation
Clearance where cover and
DC-bus cabling attaches.
56

Minimum Clearance Requirements

This section provides information to assist you in sizing your cabinet and
positioning your Kinetix 5700 drive system:
• Additional clearance is required for cables and wires or the shared-bus
connection system connected to the top of the drive modules.
– Accessory modules require extra clearance above for wiring DC-bus
stud connections and installing the cover.
• Additional clearance is required if other devices are installed above and/
or below the drive module and have clearance requirements of their
own.
– Accessory modules require extra clearance to route DC-bus wiring
into or away from the drive system.
• Additional clearance left and right of the drive module is required when
mounted adjacent to noise sensitive equipment or clean wire ways.
• The recommended minimum cabinet depth is 300 mm (11.81 in.).
Figure 20 - Minimum Clearance Requirements
29.5
(1.16) Clearance above for wiring to DC-bus
studs and lug cover installation.
MOD
DC BUS
MODULE
STATUS
Kinetix 5700 Accessory Module
(2198-CAPMOD-2240 module is shown)
Refer to the Kinetix Servo Drives Technical
Data, publication KNX-TD003, for
Kinetix 5700 drive module dimensions.
IMPORTANT
See the Kinetix 5700 Drive Module Clearance Specifications
for clearance specifications.
Rockwell Automation Publication 2198-UM002G-EN-P - February 2019
Clearance left of the
module is not required.
Mount the drive module in an upright position as shown. Do not mount the module on its
side.
Clearance above module
for airflow and installation
(see Table 19 on page 57 for values).
MOD
NET
2
1
Clearance right of the
1
module is not required.
4
I/O
Kinetix 5700 Drive Module
(DC-bus power supply is shown)
Clearance below module
for airflow and installation
(see Table 19 on page 57 for values).
table on page 57