External Passive-Shunt Connections - Allen-Bradley Kinetix 5700 User Manual

Chapter 5 Connect the Kinetix 5700 Drive System
External Passive-shunt
Connections
Shunt Resistor (RC) Connector Plug
182
Passive shunts attach to only 2198-Pxxx DC-bus power supplies. See
Shunt Considerations
power supply.
Follow these guidelines when wiring your 2198-Rxxx passive shunt:
• Refer to External Passive Shunt Modules
considerations.
• Refer to Passive Shunt Wiring Examples
• Refer to the installation instructions provided with your Bulletin 2198
shunt module, publication 2198-IN011.
IMPORTANT To improve system performance, run wires and cables in the wireways as
established in
Figure 123 - RC Connector Wiring
Table 99 - Shunt Resistor (RC) Connector Specifications
DC-bus Power Supply
Pin
Cat. No.
RC-1
2198-Pxxx
RC-2
IMPORTANT You must disconnect the internal shunt wires at the RC connector before
connecting the Bulletin 2198 passive shunt resistor wires.
Rockwell Automation Publication 2198-UM002G-EN-P - February 2019
on page 51 for shunts compatible with your DC-bus
on
on
Chapter 2.
2198-Pxxx
DC-bus Power Supply
Top View
Recommended
Wire Size
Signal
2
mm (AWG)
SH 1.5...6
DC+ (16...10)
Passive
page 74 for noise zone
page 359.
Strip Length Torque Value
mm (in.) N•m (lb•in)
0.5...0.6
12.0 (0.47)
(4.4...5.3)