Noise Reduction Guidelines For Drive System Accessories - Allen-Bradley Kinetix 5700 User Manual

Table 24 - iTRAK Power Supply
Wire/Cable
DC-/DC+ (DC bus)
iTRAK DC-bus output A and B
24V DC control input power
iTRAK 24V DC control output power A and B
iTRAK digital inputs
iTRAK ready output
Ethernet (shielded cable)
Table 25 - Capacitor Module or DC-bus Conditioner Module
Wire/Cable
DC-/DC+ (DC bus)
DC-/DC+
24V DC
Module status
Table 26 - Extension Module
Wire/Cable
DC-/DC+ (DC bus)
DC-/DC+

Noise Reduction Guidelines for Drive System Accessories

Refer to this section when mounting an AC (EMC) line filter or external shunt
resistor for guidelines designed to reduce system failures caused by excessive
electrical noise.
AC Line Filters
Observe these guidelines when mounting your AC (EMC) line filter (refer to
the figure on
• If your facility has grounded WYE power distribution, as shown in
• Good HF bonding to the panel is critical. For painted panels, refer to
• Segregate input and output wiring as far apart as possible.
Rockwell Automation Publication 2198-UM002G-EN-P - February 2019
Connector
Very Dirty
DC Bus-bar only, no wiring connector.
IDC –
CP
–
ICP
IOD –
IR –
PORT1
–
PORT2
Connector
Very Dirty
DC Bus-bar only, no wiring connector.
M8 Stud –
CP –
MS –
Connector
Very Dirty
DC Bus-bar only, no wiring connector.
M8 Stud –
page 70 for an example):
Figure 80 on page 129, mount the AC line filter on the same panel as the
Kinetix 5700 power supply and as close to the power supply as possible.
the examples on page 68.
Plan the Kinetix 5700 Drive System Installation
Zone
Dirty Clean Ferrite Sleeve
X – –
X – –
– X –
– X –
– X –
Zone
Dirty Clean Ferrite Sleeve
X – –
X – –
X – –
Zone
Dirty Clean Ferrite Sleeve
X – –
Chapter 2
Method
Shielded Cable
X
X
–
–
X
Method
Shielded Cable
–
–
–
Method
Shielded Cable
–
73