D-Link 5000 Series Cli Reference Manual page 1084

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Default
The default Route Maps are not applied.
Command Mode
BGP Router Config
11-80 neighbor route-map (IPv4 VRF Address Family Config)
To apply a route map to incoming or outgoing routes for a specific neighbor, use the neighbor route-map
command in Router Configuration mode. A route map can be used to change the local preference, MED,
or AS-PATH of a route. Routes can be selected for filtering or modification using an AS-PATH access list
or a prefix list.
Use the no command to remove the route map.
neighbor ip-address route-map map-name {in | out}
no neighbor ip-address route-map map-name {in | out}
Parameters
ip-address
map-name
in | out
Default
The default Route Maps are not applied.
Command Mode
IPv4 VRF Address Family Config
11-81 neighbor route-map (IPv6 Address Family Config)
This command specifie a route map to be applied to inbound or outbound IPv6 routes.
Use the no command to remove the route map.
neighbor ip-address route-map map-name {in | out}
no neighbor ip-address route-map map-name {in | out}
Parameters
ip-address
The neighbor's IP address.
The name of the route map to be applied.
Whether the route map is applied to incoming or outgoing routes.
The neighbor's IP address.
1078