Starter Clutch Inspection; Needle Bearing; One-Way Clutch/Clutch Outer - Honda NSA700A DN-1 2009 Service Manual

Remove the starter clutch bolts while holding the
flywheel using a special tool.
TOOL:
Flywheel holder
Remove the starter clutch from the flywheel.

STARTER CLUTCH INSPECTION

NEEDLE BEARING

Check the needle bearing fo r abnormal wear or
damage.

ONE-WAY CLUTCH/CLUTCH OUTER

Check the one-way clutch sprag for abnormal wear,
damage or irregular movement.
NOTE:
• Do not remove the one-way clutch from the
clutch outer, unless it is necessary to replace
with a new one.
• If the spring is removed from the one-way clutch
groove, replace the one-way clutch assembly
with a new one.
Check the clutch inner contact surface for wear or
damage.
Measure the clutch outer I.D.
SERVICE LIMIT: 74.46 mm (2.931 in)
FLYWHEEL HOLDER
07725-0040001 or
equivalent com­
mercially available
FLYWHEEL
Mppni _
CLUTCH OUTER
ALTERNATOR/STARTER CLUTCH
BEARING
ONE-WAY CLUTCH
BOLTS
STARTER CLUTCH
12-7