Throttle Body - Honda CBR650F Service Manual

dummyhead dummyhead
Slightly pull up the air cleaner housing.
Disconnect the crankcase breather hose [1] and air
supply hose [2] from the air cleaner housing.
Release the PAIR control valve [3] from the stay [4],
then remove the air cleaner housing from the throttle
body.
Remove the O-rings [1] from the air cleaner housing.
Installation is in the reverse order of removal.
• Replace the O-rings with new ones.

THROTTLE BODY

REMOVAL/INSTALLATION
• Always clean around the fuel system parts with
compressed air before removing to prevent dirt and
debris from entering the air passages in the throttle
body.
Remove the air cleaner housing (page 7-12).
Disconnect the following:
– Fuel injector sub harness 6P (Black) connector [1]
– IACV 4P (Black) connector [2]
– TP sensor 3P (Blue) connector [3]
– EVAP vacuum hose [4] from the hose joint [5] (TH
model only)
Loosen the throttle cable A adjuster lock nut [1].
Loosen the throttle cable B lock nut [2] then disconnect
the throttle cable B [3] from the throttle drum and cable
stay.
[1]
[3]
[2]
[1]
[3]
[2]
[1]
[5]
[3]
[1]
FUEL SYSTEM
[4]
[4]
[2]
7-13