Connecting An Ethernet Cable To The Bsr 2000 - Motorola BSR 2000 Installation Manual

Note: To maintain regulatory compliance, use only shielded cables to
connect to the BSR 2000.

Connecting an Ethernet Cable to the BSR 2000

The BSR 2000 has built-in Ethernet network interfaces for connecting to a router,
switch, or hub. The RJ-45 ports for the Ethernet interfaces are located on the left side
of the rear panel. The ports numbers are color-coded in purple and labeled 0,1,2 and 3
as shown in
To connect the BSR 2000 to the network, follow these steps.
1. Connect a male shielded RJ-45 connector at one end of the cable to the assigned
2. Connect a male RJ-45 connector at the opposite end of the network cable to one
526359-001
Figure 2-5.
Bits
RED
Figure 2-5 RJ-45 Ethernet Ports
Ethernet port on the router, hub, or switch.
of the four RJ-45 Ethernet ports on the BSR 2000.
0 1 2 3 4 5
bsr2k005
To Ethernet router,
switch, or hub
MGBI
Performing Installation Tasks
2-9