Digital Oscilloscope Status - Mitsubishi Electric MELSEC iQ-R16MTCPU Programming Manual

7.7

Digital Oscilloscope Status

The digital oscilloscope status can be checked at the digital oscilloscope monitor.
Digital oscilloscope monitor data
■Bit device
Monitor item
Sampling settings RUN
status
Sampling settings trigger
status
Sampling settings saving
■Word device
Monitor item
Sampling settings storage
target
Sample settings results save
target
Sampling settings
sampling type
Sampling settings
sampling results
Latest file information
*1 Elapsed time (seconds) up to the current time using Greenwich Mean Time 00:00:00, January 1st 1970 as the reference can be
checked.
7 DIGITAL OSCILLOSCOPE
344
7.7 Digital Oscilloscope Status
Stored content
Turns ON when sampling is started.
Turns OFF when saving of the sampling results is
complete.
Turns ON when trigger conditions are established.
Remains ON even when sampling is complete, and turns
OFF when starting sampling.
Turns ON while saving data in the buffer data to the storage
target when performing sampling.
Stored content
The storage target for the sampling settings file being
sampled is stored.
The sampling results save destination for the data being
sampled is stored.
The sampling type being sampled is stored.
The latest sampling results file information (system time
is stored.
Monitor value Refresh cycle
OFF: STOP When sampling
ON: RUN status changes (main
cycle)
OFF: Before trigger When trigger ON
ON: After trigger (sampling cycle)
OFF: Not while saving When file save status
ON: While saving changes (main cycle)
Monitor value Refresh cycle
0: No sampling When starting
1: Standard ROM sampling (main
2: SD memory card cycle)
0: No sampling
1: Standard ROM
2: SD memory card
0: No sampling
1: Trigger sampling
*1
) Latest saved file When outputting
information sampling results
(main cycle)
Device No.
SM760
SM761
SM762
Device No.
SD760
SD761
SD762
SD764,
SD765