■Port No.
Set the port number used for communication with the vision system. Set the same number as the port number set for the
vision system with In-Sight
• For Telnet communication
Set the Telnet connection port number used to control the vision system from the Motion CPU.
If this number is not set, the Telnet default port number (23) will be used.
• For TCP/IP communication
Set the vision system's TCP/IP server port number used to batch send the vision system job execution results with the
format output string setting of TCP/IP protocol. This does not need to be set when not using the format output string setting
of TCP/IP protocol.
■User Name
Select a user from those set in the vision system to be used when executing the vision system dedicated functions.
Select a user name for which the access level is set to "Full Access" or "Protect" in the In-Sight
list.
■Password
Set the password corresponding to the set user name.
■Status Storage Device
Set the word device in which the vision system status and vision system dedicated function error codes are set.
Refer to device list for the range of word devices that can be set. (Page 75 Device List)
Set the device No. as an even-number.
The vision system status and error code of vision system dedicated function are stored in two successive points of the
specified device as shown below.
Vision system status
Error code of vision system
dedicated function
6 COMMUNICATION FUNCTIONS
316
6.5 Vision System Connection Function
Explorer.
Specified device
+0
+1
Explorer user