Parameters Used With Parameter Change - Mitsubishi Electric MELSEC iQ-R16MTCPU Programming Manual

Parameters used with parameter change

The list of parameters that are stored in special registers (SD841 to SD845) are shown below.
Parameter
Motion CPU Basic setting
common
Servo network setting
parameter
High-speed input request signal setting
Mark detection setting
Limit switch output setting
Manual pulse generator connection setting
Vision system parameter (Ethernet
communication line setting)
Vision system parameter (Vision program
operation setting)
Head module setting
Multiple CPU refresh (Main cycle/operating
cycle) setting
4 AUXILIARY AND APPLIED FUNCTIONS
130
4.10 Parameter Change Function
Parameter No. Axis No.(Line No.)
(SD841) (SD842)
1 0
2 1 to 2
3 0
4 0
5 0
6 0
7 0
8 0
9 0
10 0
Details
Page 132 Basic setting (parameter No. 1)
Page 132 Servo network setting
(parameter No. 2)
Page 133 High-speed input request
signal setting (parameter No. 3)
Page 134 Mark detection setting
(parameter No. 4)
Page 135 Limit output data setting
(parameter No. 5)
Page 135 Manual pulse generator
connection setting (parameter No. 6)
Page 136 Vision system parameter
(Ethernet communication line
setting)(parameter No. 7)
Page 136 Vision system parameter
(Vision program operation setting)(parameter
No. 8)
Page 137 Head module setting
(parameter No. 9)
Page 138 Multiple CPU refresh (Main
cycle/operating cycle) setting (parameter No.
10)