Checking Washer Liquid; Checking And Cleaning Engine And Electrical Wiring; Washing Whole Machine; Greasing Front Attachments (Without Bucket Pin And Boom Swing Fulcrum) - Kubota U35-4 Operator's Manual

BChecking Washer Liquid
If the windows washer is switched on with the washer
liquid tank empty, the motor may be damaged. Always
keep the tank filled.
(1) Washer liquid tank
BChecking and Cleaning Engine and
Electrical Wiring
To avoid personal injury or death:
A Always stop the engine and remove the key
before cleaning the wiring, cables and engine.
Before starting, check whether flammable substances
have gathered on the battery, the cables and wiring, the
muffler or on the engine. Remove thoroughly.
Check the electrical circuitry for disconnections, shorts or
loose terminals.
BWashing Whole Machine
A Do not wash the excavator with the engine running.
Water could enter the air filter and damage the engine.
Make sure that the air filter is kept dry.
A Remove the mud before washing the machine.
BGreasing Front Attachments (without
Bucket Pin and Boom Swing Fulcrum)
To avoid personal injury or death:
A First lower all attachments on the ground then
stop the engine and remove the key.
A While greasing, take care not to step on the
bucket teeth.
A When doing excavation work in water, generously
grease the following points. After ending work, grease
again.
Grease the marked grease fittings shown by arrows in the
illustration below.
(1) Boom bottom linkage
(2) Arm bottom linkage
(3) Boom cylinder boss
(4) Arm cylinder boss
(5) Bucket cylinder boss
(1) Swing cylinder boss
MAINTENANCE 61