Important Inspection Items After Reassembling - Kubota K008-3 Workshop Manual

K008-3, U10-3
D. IMPORTANT INSPECTION ITEMS AFTER REASSEMBLING
a. Operate the machine and check for unusual noise and vibrations.
b. Make sure the safety decals and wireharness clamps are in their specified posi-
tions.
c. With the machine front in a specified posture, check the amount of hydrauric oil.
Checking the oil level (For further datails, refer to the Operator's Manual of each model.)
CAUTION
To avoid personal injury:
• First lower all attachments on the ground then stop the engine.
IMPORTANT:
• Before filling with oil, wipe away all sand and dust from around the oil port. Make sure you use an identi-
cal type of hydraulic fluid.
• The excavator has been filled with hydraulic fluid before delivery. See "RECOMMENDED OILS". (Do not
mix different makes!)
1. Move the excavator on to level ground. Extend every
cylinder rod up to its center position, track width
increases 2 ft. 9.9 in. (860 mm) and place the bucket in
contact with the ground.
2. Check the oil level as to whether it lies on the center
mark under normal temperature 50 to 86°F (10 to
30°C).
3. Enough oil is present if the oil level lies between the
markings.
4. Should the oil level be too low, fill with oil through the oil
port before starting the engine. This step is important
for the protection of the hydraulic system.
(1) Specified oil level
(2) Tank cap
I-S-6-2
1
I. GENERAL