Replacing Fuel Hose; Replacing Intake Air Line - Kubota KX 016-4 Operator's Manual

Stop the engine then remove the key and wait until
machine has cooled down completely.
1. Open the drain plug on the bottom of the radiator and
drain coolant completely, Should a reserve tank be
equipped, disconnect the line from the tank floor and
then open the drain cock.
2. To clean, rinse the radiator with water.
3. Close the drain plug and fill the radiator and the
reserve tank with coolant fluid. Let the engine idle for
about 5 min., stop the engine and remove the key then
check the coolant level.
4. The machine has been shipped filled with 50% anti-
freeze solution.
(1) Drain plug
(1) Radiator cap
REGULAR CHECKS AND MAINTENANCE WORK
(1) Reserve tank
Radiator
Reserve tank
A Do not operate the engine without coolant.
A To fill the radiator system and the reserve tank, use
fresh water and anti-freeze fluid.
A When the anti-freeze is mixed with water, the anti-
freeze mixing ratio must be less than 50%
A Tighten the radiator cap properly. If the cap is loosely
or not properly fitted, overheating of the engine can
result due to coolant fluid loss.
BReplacing Fuel Hose
Replace the hoses and clamps.
(Contact your local KUBOTA dealer for details.)
BReplacing Intake Air line
Replace the hoses and clamps, if necessary.
(Contact your local KUBOTA dealer for details.)
(A) "FULL"
(B) "LOW"
approx. : 2.7 L
approx. 0.56 L
55