Power-Inline Allow-Legacy - Centrecom FS980M/9 Command Reference Manual

P E C
OWER OVER THERNET OMMANDS
- -
POWER INLINE ALLOW LEGACY

power-inline allow-legacy

Overview This command enables detection of pre-IEEE 802.3af Power Ethernet standard
legacy Powered Devices (PDs).
The no variant of this command disables detection of pre-IEEE 802.3af Power
Ethernet standard legacy Powered Devices (PDs).
Syntax power-inline allow-legacy
no power-inline allow-legacy
Default Detection of legacy PDs is enabled on all ports
Mode Global Configuration
Examples To disable detection of legacy PDs, use the following commands:
awplus#
awplus(config)#
To enable detection of legacy PDs, use the following commands:
awplus#
awplus(config)#
Validation show power-inline
Commands
show running-config
613-50137-01 Rev A
configure terminal
no power-inline allow-legacy
configure terminal
power-inline allow-legacy
power-inline
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
547