P
E
C
OWER OVER
THERNET
OMMANDS
-
SHOW POWER
INLINE COUNTERS
show power-inline counters
Overview
This command displays Power over Ethernet (PoE) event counters for ports on the
Power Sourcing Equipment (PSE). The PoE event counters displayed can also be
accessed by objects in the PoE MIB (RFC 3621). See
Overview and Configuration Guide
are supported.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show power-inline counters [<port-list>]
Syntax
Mode
User Exec and Privileged Exec
Examples
To display all PoE event counters for all PoE ports, use the command:
awplus#
To display the PoE event counters for the port range 1.0.1 to 1.0.3, use the
command:
awplus#
Output
Figure 16-3: Example output from the show power-inline counters command
Table 2: Parameters in the show power-inline counters command output
613-50137-01 Rev A
Parameter
Description
<port-list>
Enter the PoE port(s) to display PoE event counters for them.
show power-inline counters
show power-inline counters interface port1.0.1-1.0.3
awplus#show power-inline counters interface port1.0.1-port1.0.3
PoE Counters:
Interface
MPSAbsent Overload Short Invalid Denied
port1.0.1
0
port1.0.2
0
port1.0.3
0
Parameter
Description
Interface
The PoE port(s) in the format portx.y.z, where x is the device
number, y is the module number within the device, and z is the
PoE port number within the module.
MPSAbsent
The number of instances when the PoE MPS (Maintain Power
Signature) signal has been lost. The PoE MPS signal is lost when a
PD is disconnected from the PSE. Also increments
pethPsePortMPSAbsentCounter in the PoE MIB.
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
for information about which PoE MIB objects
0
0
0
0
0
0
0
0
0
the MIB Objects Feature
"Getting Started
Guide.
0
0
0
560